Before purchase, please note:
Some styles and sizes of door handle will not be compatible with a standard HandleStay, or a large HandleStay. If in doubt, please enquire via the contact form.
Your door will need to open against a wall or similar feature, within 28mm (32mm for the large variant) of it per the dimensions shown via the links at the bottom of this page, to allow suitable HandleStay installation. Again, if in doubt, please enquire.
Installation
Be careful when aligning before making any holes – there is a ‘sweet spot’ for location which will vary depending on handle form, door swing, etc. This will become clear as you test during installation.
Note, to allow access to the mounting hole in your HandleStay, the latch must be in the lowered ‘Install / Stow’ position (as it is when shipped to you). If it is in the ‘Operating’ position, firmly hold the mounting component and ‘click’ the latch downwards.
Each HandleStay is supplied with a wall plug for a Ø6mm masonry hole, and a stainless steel screw. Be careful not to over-tighten.